Metrix SX-ASYC2 Manual De Instrucciones página 26

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Precisions
*
Programming the relative reference
The relative reference extension characters (Y...) are: D0, D1, D2, D3, D4 +
G/S +CR
Each character D0 to D4 can be one of the values 30H to 39H.
D0 is the low order of the reference, and D4 is the high order.
The G/S character contains the range number (see ****), and the reference sign
(add 8 in hexadecimal to the range number when the sign is negative).
$
Example
ASCII
HEXA
signifi-
meas.
cation
config.
** Programming the ohm reference in dB and in resistive power
The extension characters (Y...) of the ohm reference are: D0, D1, D2, D3 + CR
Each character D0 to D3 can be one of the values 30H to 39H. Therefore the
ohm reference may be programmed from 1 ohm to 9999 ohms.
$
Example
ASCII
HEXA
significa-
tion
***
Programming the rate of timer data
The 6 timer programming extension characters (Y...) are S0, S1, M0, M1,
H1CR
They represent Hours (0 to 9), Minutes (00 to 59) and Seconds (00 to 59).
Each character may be equal to 30H to 39H.
$
Example
II
- 10
Reference to be programmed: 36.187 volts
the reference programming message contains the following 10
characters:
2
3
:
32H
33H
3AH
relative reference
programmation
Ohm reference to be programmed: 600Ω
The message contains the following 8 characters:
2
3
32H
33H
meas.
programmation
config.
référence ohm
Program timer at 7h 36 mn 42 sec
7
8
4
37H 38H
34H
reference absolute value
;
0
6
3BH 30H 36H
reference value
6
3
:
36H
33H
3AH
range no. 2
volts (32H)
and
negative
sign (+8H))
0
0
CR
30H
30H
0DH
SX-ASYC2
CR
0DH

Publicidad

Tabla de contenido
loading

Tabla de contenido