Set Up Seca 465; Adjust Paper Sensor - Seca 465 Manual De Instrucciones Y Garantía

4.3 Set up seca 465

Adjust paper sensor

− Ensure that the power supply cable is not
bent, twisted or subjected to tension when
the printer is in use or being transported.
− Do not try to modify the power supply cable.
− Do not route the power supply cable close to
heaters.
− Ensure that the power supply socket used is
always freely accessible.
− Disconnect the power supply plug from the
power supply socket if you do not intend
using the device for an extended period.
− Always hold the power supply cable by the
plug when you take it out of the power supply
socket.
1. Ensure that the On/Off switch of the device is set to
"Off".
2. Plug the power supply cable into the power supply
unit.
3. Plug the cable for the power supply unit into the
connecting socket on the printer.
4. Plug the power supply cable into a power supply
socket.
The paper sensor enables the device to detect when
the paper roll is coming to an end. For this feature to
function reliably, the paper sensor must be set to suit
the type of paper roll in use.
NOTE
• The printer is preset for a paper roll diameter
(∅ paper roll) of 22 mm. You do not need to
perform the steps in this section for the
thermal paper available from seca (see
"Accessories" on page 75).
• The paper sensor works only with thermal
paper. This function is not available for labels.
1. Ensure that the device is switched off.
2. Open the paper compartment cover.
3. Adjust the lever to the correct position as shown in
the table below.
Before you get started ... • 51
English