Installing The Cooktop - Kenyon B41603 El Manual Del Propietario

Allow a 2" minimum clearance between the bottom of the metal pan of the cooktop and any combustible surface located
below, ie: the upper edge of a drawer installed below the cooktop (see Fig. B on previous page). Failure to provide proper
clearances and ventilation may result in a fire hazard.
Cooktop dimensions and countertop cutout dimensions for each model are shown below:
2 5/8"
2 5/8"
Note:
When making countertop, radius the corner of the cutout (1/4" radius is typical). This will prevent cracking of
the countertop. Follow the countertop manufacturer's instructions regarding the minimum corner radius and
reinforcement of corners.
STEP #4

Installing the Cooktop

The cooktop is supplied with two metal mounting brackets.
These brackets are designed to hold the cooktop firmly in place.
The cooktop does not have a metal frame and should be sealed
to the countertop. Use a soft bedding compound that will
prevent damage if later removal for service is necessary.
We recommend a nonadhesive type of sealant, such as
plumber's putty, maximum compressed thickness of 1/16".
Silicone may be used to seal the glass edge only, if desired.
14 1/4"
23 1/4"
3 1/4"
21 3/4" 12 3/4"
Models: MED2, ALP2LG
12" 12 1/2"
3 1/4"
10 3/4"
11 1/2"
Models: MED1, CAR1, ALP1, CORT1
12"
2 5/8"
20"
Models: MED2TL, CAR2, ALP2SM, CORT2
21"
2 3/4"
2 3/4"
16"
Models: ARCTIC2, ANTARCTIC2 & GLACIER2
glass panel
4
21"
3 1/4"
10 3/4"
17"
3 1/4"
19 1/2"
silicone to seal the
glass edge if desired
p u t t y s t r i p
counter top