Maintenance; Troubleshooting - Truper COMP-AERO Manual Del Usario

Cleansing and Care
• Always keep the ventilation slots clean and free of
obstructions to guarantee the proper cooling of the motor.
• Inspect regularly all the mounting nuts and double check
for proper tightness. In case there are lose nuts, tighten
immediately.
After Each Use
• Drain the water trap: have the compressor running. Raise
the drain valve (C) in the bottom of the water trap. This way,
humidity condensed inside the compressor is eliminated.
Every Three Months
• Clean the carrier filter element (D) using compressed air.
Problem
The motor is not
running.
The motor starts but
makes irregular or
clacking noises.
There is not enough
pressure when
painting or spraying.
The motor is running
correctly but there is
no air pressure or air
supply failure.
8
ENGLISH
Cause
• There is no power • Connect the power cord into a grounded 110 V power outlet.
supply.
• The power cord is • Take the tool to a
damaged.
• The electric wiring • Take the tool to a
inside the unit is
defective.
• The switch is defective. • Take the tool to a
• A bearing is loose or • Take the tool to a
damaged.
• Loose screws in the • Take the tool to a
rod.
• Loose air • Check all air connections and tighten as necessary.
connection(s).
• The air hose is • Replace the air hose.
damaged.
• The screws in the • Tighten the screws.
cylinder cover are loose.
• The valve plate is out • Take the tool to a
of place.
• The retention ring is • Take the tool to a
damaged after excessive
use of high pressure.

Maintenance

Service
• Service to the tool shall only be carried out in a
Authorized Service Center. Service
and maintenance carried out by non-certified people may
result dangerous o cause personal injuries and voids he
product warranty.
D
C

Troubleshooting

Solution
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.