Overload Protector; Suction Control; Thermal Protector - Kenmore 116.29219 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PERFORMANCE
FEATURES
i
WARNING
Personal Injury Hazard
Always turn off and unplug the vacuum
cleaner before cleaning the agitator area
as agitator may suddenly restarL
Failure to do so can result in personal
injury.
OVERLOAD
PROTECTOR
The Power-Mate
Overload Protector/
has built-in
protection against
motor and belt
damage should the
agitator jam If the
agitator slows down
or stops, the
overload protector shuts off the Power-Mate.
The canister motor will continue to run.
To correct problem: Turn off and unplug
vacuum cleaner, remove obstruction,
then
press BELT RESET button. A bali point
pen may be required to press button
If the problem persists, have the
vacuum cleaner serviced
by a Sears or
other qualified service
agent,,
EDGE
CLEANER
Active brush edge
cleaners are on both
sides of the Power-
Mate. Guide either
side of the Power-Mate
along base-boards or
next to furniture to
help remove dirt
trapped at carpet
edges
SUCTION CONTROL
The suction
control allows
you to change
the vacuum
suction for
suction
sutton
different fabrics
and carpet weights. Opening the control
decreases suction for draperies and
lightweight rugs, while closing the contro!
increases suction for upholsteries and
carpets
THERMAL PROTECTOR
This vacuum cleaner has a thermal
protector which automatically trips to protect
the vacuum cieaner from overheating
tf a
clog or a full dust bag prevents the normal
flow of air to the motor, the thermal
protector turns the motor off automatically.
This allows the motor to cool in order to
prevent possible damage to the vacuum
cleaner.
To correct problem: Turn the vacuum
cleaner off and unplug the power cord
from the outlet to allow the vacuum
cleaner to cool and the thermal protector
to reset,, Check for and remove clogs or
replace the dust bag, if necessary.
Also
check and replace any clogged filters,,
Wait approximately thirty (30) minutes
and plug the vacuum cleaner in and
turn back on to see if the motor
protector has reseL
13

Publicidad

Tabla de contenido
loading

Tabla de contenido