First Step - Activate remote by moving hold
switch to on position . Orange dot not visible.
Music Browsing
Before proceeding, make sure the iPod is docked into the JBL on stage
position so that the orange dot is not visible.
Turn iPod® On:
Turn iPod® Off:
Play a Track:
Pause a Track:
Skip to Next Track:
Skip to Previous Track:
Fast Advance Track:
Fast Reverse Track:
Increase Volume:
Decrease Volume:
Lock Remote Buttons:
Mute:
Photo Browsing (iPod® in photo browsing mode)
TM*
The JBL on stage
II remote control can be used to browse images on your iPod® Photo player. To do so, the
remote control needs to be in the Photo Mode by following two steps listed below:
1. Set the Hold switch on the JBL on stage
2. Press and hold the Play/Pause button and at the same time and slide the Hold switch to Active (an orange dot
not visible).
The remote is ready to browse photos forward or backward by pressing the Volume Up and Volume Down buttons,
respectively. (not enabled for TV Out).
To exit Photo mode, slide the Hold switch from Active to Hold, then back to Active.
If you have any questions, or need further assistance, please visit www.JBL.com.
8
Easy Setup Guide
Volume Down
®
Press any button on the remote control to wake the iPod®.
Press and hold the Play/Pause
Press the Play/Pause
pressing Play/Pause will cause the iPod® to start playing all of its music.
Press the Play/Pause
Press the Forward
Press the Reverse
Press and hold the Forward
Press and hold the Reverse
Press the Volume Up
Press the Volume Down
Move hold button up (orange dot visible).
Press the Volume Up
TM*
II Remote (orange dot visible).
Previous/Fast Reverse
TM*
button for 2 seconds.
button. Note: If the iPod® is at the Main Menu,
button while a song is playing.
button.
button.
button.
button.
button.
button.
and Volume Down
Play/Pause
Power Off
Next/Fast Forward
Hold Switch
Volume Up
II and the remote Hold Switch is in a
buttons at the same time.