Electrical Connections - Dri-Eaz Rover HVE Manual Del Propietário

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

3. While extracting, create an overlapping pattern for best

results. Overlap each pass by about half the width of the

previous pass.

4. To turn the Rover HVE in another direction, gently move

the joystick in the direction needed. Do not do "wheelies"

or jerk the unit sideways; this may cause delamination

damage to carpet.

5. The Rover HVE will drive straight ahead, straight backward

and turn in a full circle. Ideally, extract with the grain of the

carpet. If the Rover HVE begins to track (i.e. stops moving

in the direction the joystick is moved) it needs to be re-

calibrated. To do this, push the joystick forward and press

the calibration button on the product label side of the con-

trol box at the same time (the calibration button is shown in

the drawing on page 1; look for mark indicating button loca-

tion in center of "H" on the product label).

6. Run the unit on Low speed if carpet and pad are extremely

wet, then on High speed as the carpet and pad become

less wet.

7. From time to time, check the clear take-up tube leading to

the hose connection. (Shown, below) When the tube indi-

cates that only a small amount of water is being removed,

stop extracting to minimize any carpet delamination.

Check clear take-up tube during extraction.

Clear take-up tube

Transporting and Storing

1. To prepare the Rover HVE for transporting, loading into a

van or for storage, first lay it on a flat surface (with small

front loading wheels facing up). While supporting the han-

dle with one hand, pull out the pins on each side with the

other hand. Next fold the handle all the way down to the

horizontal position, then replace the pins to lock the handle

down. Pick up unit by handlebars and place unit upright

onto the small front-loading wheels. Wrap the power cord

around your arm then place in the cord compartment lo-

cated under the unit. Use the small front loading wheels for

ease of transporting while using the molded-in handle to

assist in loading or carrying the unit.

2. When transporting in a van, secure the Rover HVE against

the wall (Shown, below) and strap it into place.

NOTICE! Store securely in an upright position to avoid any

damaging impact to the motor, gears, and other internal

parts.

Store securely in upright position.