Fluke EBC290 Manual De Instrucciones página 2

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 7
Symbols
Risk of Danger. Important information. See
Instruction Sheet.
Do not dispose of this product as unsorted municipal
waste. Go to Fluke's website for recycling
information.
Conforms to relevant European standards.
Specifications
Electrical Specifications
Power connection
Adapter requirement
Input current limitter
Input voltage range
Battery type
Capacity
Charge time
Charge operating range
Charge disable protection
(smbus controlled)
Charge disable protection
(hardware controlled)
General Specifications
Temperature:
Operating
Non-Operating (Storage)
Maximum Relative Humidity
Non-Operating (Storage):
Operating:
0 ... 10 °C
10 ... 30 °C
30 ... 40 °C
40 ... 45 °C
Emission and Immunity
Height x Width x Depth
(excluding battery)
Weight
BC190 or BC430
17.8 V / 0.84 A
714 mA ±5%
15 to 23 V
BP291
BP290
52 Wh
26 Wh
5.5 hours
< 3 hours
0 to 45°C (determined by battery)
54°C ±3°C battery temp
(determined by battery)
58°C ±3°C battery temp
(determined by battery)
0 °C to +45 °C
(determined by battery)
-20°C to +60 °C
No precipitating (noncondensing)
Recovery time two hours
No precipitation (noncondensing)
95 ± 5 %
75 ± 5 %
45 ± 5 %
EN-IEC-61326-1
(first edition 2005).
44 x 65 x 100 mm
85 g
Using the EBC290
To use the EBC290, follow these instructions (Refer to Figure 1):
1.
Connect the Power Adapter BC190 (or BC430) to a mains outlet
and insert the DC plug of the Power Adapter into the External
Charger.
3
2.
Insert the battery to be charged into the External charger. Take
careful notice of the correct placement of the battery.
3.
Observe the green LED indicator:
- Slow flashing indicates that the battery is charging.
- Continuously on indicates that the battery is fully charged.
- Fast flashing indicates a battery error.
4.
During the charging process the number of segments to turn on
in the battery display will increase over time. All segments on
indicates that the battery is charged to 100 % of its present
capacity.
Cleaning
Before cleaning, separate the product from Power Adapter and
Battery.
Clean the EBC290 with a damp cloth and a mild detergent. Do not
use abrasives, solvents, or alcohol.
Troubleshooting
In case of an error, the green LED in the Charger will flash at a high
rate which indicates a possible battery problem. When available,
insert another battery to determine is the error is caused by the
battery or by a defective charger.
4
2
1
Fig. 1

Publicidad

Tabla de contenido
loading

Productos relacionados para Fluke EBC290

Tabla de contenido