EGO PSA1000 Manual Del Usuario página 23

NOTICE:
If there is difficulty in removing
the bar and chain from the mounting
surface, place the pole saw upright,
with one hand supporting the bar, and
loosen the chain-tensioning screw
counterclockwise with the other hand
(Fig. 10). Then remove the bar with the
chain.
NOTICE:
This is a good time to inspect
the drive sprocket for excessive wear or
damage.
Assembling the New Bar and
Chain
1. Lay the new saw chain in a loop on
a flat surface and straighten any
kinks (Fig. 11).
2. Place the chain drive links into the
guide-bar groove. Position the chain
so there is a loop at the back of the
guide bar (Fig. 12).
3. Hold the chain in position on the
guide bar and place the loop around
the sprocket of the pole saw.
10
11
12
Chain Drive
Links
Guide-bar Groove
POLE SAW ATTACHMENT — PSA1000
Chain-tensioning Screw
23