Alcad 912-TQ Guía Rápida De Programación página 4

QUICK PROGRAMMING GUIDE 912-TQ DVB-S/S2 TO DVB-C
Output
Program by
Channel
Channel
Frequency
Channel table
BG CCIR
Channel
21
Frequency
471.25
Attenuation
14
Symbol rate
✓ Auto
Modulation
64QAM
QPSK
16QAM
64QAM
128QAM
256QAM
Spectrum
Normal
Normal
Inverted
Services
(FTA) Free to air service 1
(FTA) Free to air service 2
(FTA) Free to air service 3
(FTA) Free to air service 4
(FTA) Free to air service 5
BW total
79%
Orig Net Id
1
TSID
1078
Set the programming switch of the 912-TQ module to the OFF position. The programming
MHz
dB
1000 KBd
✓
TV 12%
✓
TV 11%
✓
TV
10%
✓
TV 13%
✓
TV 12%
Network ID
1
indicator light will now go out.
Select the programming mode for the output of the
OK+ +OK+T
module: channel or frequency. Then press T to transmit.
Select the standard for the output channel. Then press
OK+ +OK+T
T to transmit.
If the output is programmed by channel, it is possible to
Keypad + T
enter the channel using the numeric keypad. Alternatively,
o
you can select a channel from the pull-down list. When
OK+ +OK+T
you have confi rmed your choice by pressing OK, press
T to transmit.
If the output is programmed by frequency, enter the
Keypad + T frequency using the numeric keypad. Then press T to
transmit.
Keypad + T
Enter the attenuation at the output of the module
or
using the numeric keypad. Then press T to transmit.
OK+ +OK+T
Enter the symbol rate of the output signal using the
Keypad + T
numeric keypad. Then press T to transmit.
Select the type of modulation of the output channel. Then
OK+ +OK+T
press T to transmit.
Select the type of spectrum. Then press T to transmit.
OK+ +OK+T
Press the READ key to obtain a reading of the services
READ
available in the input transponder.
Select the services that you wish to distribute, marking
them with
OK+ +OK
that you should not use more than 90% of the available
BW.
Once the desired services have been selected, press T
T
to transmit.
Using the numeric keypad, you can enter a TS identifi er
Keypad + T
(TSID), should that be necessary for your installation.
Then press T to transmit.
✓
(by pressing the OK key). It is recommended
ENG