Brinly-Hardy DT-402BH Manual Del Propietário página 6

================================================================================================
Attach the Wheel Bracket (4) to the Tray (8) using the hardware
4)
in Panel 4 as shown in Figure 4.
NOTE: Tighten the nuts assembled in this step to allow the
Wheel Bracket Assembly to rotate with minimum "side to
side" looseness.
5) Starting with the 90 degree bent end, assemble the Control
Rod (5) into the left hole on the Wheel Bracket (4) as shown in
Figure 5. Feed Control Rod (5) through hole until opposite end
engages with Wheel Bracket (4).
NOTE: The Control Rod Must Be orientated as shown in
Figure 5 after assembly.
6A) Orientate Handle (3) between Towbars. Attach the end of the
Control Rod (5) with the 90 degree bends to the Handle (3) as
shown in Figure 6.
6B) Assemble the handle onto the Bolt (12) that runs through the
Lift Lock (2) as shown in Figure 6. Orientate Handle so that it
is engaged with one of the Tine height settings on the Lift Lock
(2). Figure 7 shows the handle in set to dethatch mode.
CAUTION: Avoid Injury! Movement and Tine height
adjustment of Handle, Lift Lock, and Spring can be
a pinch point. Take care when working in this area.
1018604-A
ASSEMBLY
Figure 4
Figure 5
NOTE: Tines and Safety
Figure 6
6
NOTE: Tines and Safety
22
16
4
4
Wires not shown.
3
Wires not shown.
8
16
22
5
After assembly,
this end should
be engaged
with Wheel
Bracket (4).
2
12
5
Englist Manual