Waxman LeakSmart Manual De Instalación Y Funcionamiento página 3

LeakSmart Water Heater Kit
This Package Contains:
A (1) LeakSmart Motorized Brass Water
Ball Valve (3/4" FIP x 3/4" MIP)
B (1) LED Control Panel
C (1) Water Leak Sensor with paper sleeve
D (1) AC Power Adaptor (6 ft. length)
E (1) Wire Harness
F (1) Hook & Loop Mounting Pad
G (2) Mounting Screws with Anchors
C
Check to make sure everything in the package matches the Contents Listing above.
Read the instructions thoroughly before installing or operating the LeakSmart system.
WARNING: Do not put finger(s) inside the LeakSmart Valve. Risk of serious injury may occur.
CAUTION: Do not grip plastic motor drive for leverage when tightening the
LeakSmart Valve.
WARNING: LeakSmart is for indoor use only! Do not install LeakSmart outdoors!
WARNING: For use with water only. Do not install on gas line.
WARNING: Do not use this product on fire suppression sytems or fire sprinkler water lines.
B
A
F
D
G
E
4.
STOP: Read the instructions thoroughly before installing or operating the
LeakSmart System. You may need to purchase additional fittings to install the
LeakSmart Valve. If you are not sure how to install the LeakSmart Valve to your
existing water line, we recommend that you contact a licensed Plumber.
Preparation
Step 4 instructs you to install the LeakSmart Valve (3/4" FIP x 3/4" MIP) between the rigid water line
coming off the manual cold water valve and the water heater. Most rigid lines will be copper. Evaluate
your line and determine which size adapter fitting you will need (the most common one will be 3/4"
solder x 3/4" male adaptor and 3/4" solder x 3/4" female adaptor). Then determine what size union
you will need between the LeakSmart Valve and the water heater. Check your local plumbing codes for
proper installation.
CAUTION: Make sure the LeakSmart Valve is not connected to the adaptor fitting(s) when soldering.
LeakSmart Water Heater Kit
5.