Hardware Installation; Before Installation - Planet POE-151 Manual Del Usuario

5. Hardware Installation

This section describes the hardware features of PoE Injector. Before
connecting any network device to the PoE Injector, refer to this chapter
carefully.

5.1 Before Installation

Before your installation, it is recommended to check your network
environment. The PLANET PoE Injector is with an AC-DC adapter and
inject the DC power into the pin of the twisted pair cable follow the IEEE
standard, the power and pin assignment relationship is the table below:
Required AC-DC adapter
Model
Spec.
POE-151
Input: 100~240V AC
Output: 48V DC
POE-152
Input: 100~240C AC
POE-161
Output: 56V DC
Category 5/5e/6 UTP/STP cable that with 8-wire are required for the
installation. UTP cable with 4-wire (pin 1/2, 3/6) can not work with
POE-151/161 and only can work with POE-152 in 10/100Base-TX
Ethernet.
PLANET PoE Injector and PLANET PoE Splitter (ex.
POE-151S, POE-152S and POE-162S) can be installed
in pair. Use of third-party device is allowed if the device
Note
complied with IEEE 802.3at or IEEE 802.3af standard.
5.2 PoE Injector Installation
1. Connect a standard
"Ethernet" port of PoE Injector.
2. Connect the long cable that will be used to connect to the remote
device to the port "Ethernet+DC".
3. Connect the AC adapter to "DC 48V" of POE-151/POE-152. The
power LED will be steady on. Connect the AC adapter to "DC 56V" of
POE-161. The power LED will be steady on.
network cable from
PoE Pin Assignment
4/5(+), 7/8(-)
1/2(+), 3/6(-)
4/5(+), 7/8(-)
Switch/workstation to
1-3