JANE MONTECARLO R1 Manual Del Usuario página 28

Ocultar thumbs Ver también para MONTECARLO R1:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
If you are going to install your MONTECARLO R1 with the rigid an-
chors, follow the steps below carefully:
First remove the end caps, to do this, pull the anchor button. Keep
3a
the end caps in case you use the MONTECARLO R1 without ISOfix
in the future.
Pull the anchor out pressing the red buttons on the sides (13).
3b
3c
Make sure that both anchors are open, the red signal should be
displayed on the anchor button (12).
Place your MONTECARLO R1 on the vehicle seat in accordance with
the advice and warnings contained in the GENERAL INSTRUCTIONS.
Before installing the safety seat find the ISOfix anchors on the vehicle
seat. Once you have found them, position the MONTECARLO R1 so
that the rigid anchors (11) are pointing towards the ISOfix anchors of
the vehicle.
3d
Press the rigid anchors towards the vehicle seat until they both
lock, check that the green signal is displayed on the two ISOfix re-
lease buttons (12).
Keep pressing firmly until the booster seat touches the backrest
3e
of the vehicle seat. Make sure that it is securely held by pulling
the seat.
3f
Place the child in the MONTECARLO R1 and make sure that he is
sitting well back, pass the seat belt over him and fasten it
Insert the shoulder belt into the red clip on the headrest (9)
3g
28
IM-1388.06 MONTECARLO R1.indd 28
Pass the abdominal belt under both armrests of the booster seat,
3h
the area where the belt should go is marked in red again (10). Last-
ly, tighten the seat belt.
To get the child out of the seat, simply unfasten the seat belt. When
you want to remove the MONTECARLO R1 safety seat from the vehi-
cle, pull the buttons on the ISOfix anchors (12) while removing the
booster seat.
Universal: just with the 3-point seat belt
Place your MONTECARLO R1 on the vehicle seat in accordance with
the advice and warnings contained in the GENERAL INSTRUCTIONS.
To protect the upholstery of your vehicle, put the caps on the ISOfix
terminalPlace the child in the MONTECARLO R1 and make sure that he
is sitting well back, pass the seat belt over him and fasten it.
28/10/16 10:39

Publicidad

Tabla de contenido
loading

Tabla de contenido