Powermate PWLE0799.1 Manual Del Usuario página 14

Maintenance
• Save all instructions
B
Lubrication
Add a small amount of engine oil to lubricate parts and
pivot points . Refer to "Periodic Maintenance Schedule
Table" for time intervals to lubricate parts .
C
How to Change the Engine Oil
NOTE: Refer to Figure 10 when following the steps below:
1 . Stop the engine and let it cool .
2 . Disconnect spark plug wire from the spark plug .
3 . Raise the front of the unit, by lowering the height of the
front wheel . Refer to "How to Edge Along a Curb" .
4 . Insert a flat pan under the edger, underneath the oil
drain plug and frame hole .
5 . Remove oil dipstick . (See Figure 3)
6 . Remove the oil drain bolt and washer .
7 . Allow all oil to drain through the frame hole into the pan .
IMPORTANT: Used oil is a hazardous waste. Place oil in a
sealed container and take to your local recycling center. Do
NOT discard with household waste.
8 . Replace and tighten the oil drain plug and washer .
9 . To re-fill engine with oil, see engine preparation section
"How to Check Oil and Fill to Proper Level".
D
How to Replace the Belt
IMPORTANT: Only use a replacement belt from the manufacturer.
To order spare parts call us at 1-800-737-2112.
1 . Disconnect the spark plug wire from the spark plug .
2 . To ease the replacement of a belt, remove the control rod
(See Figure 2) . This will allow the quill arm to rotate back
creating slack in the belt .
3 . Remove the two rear guard bolts to remove the engine
pulley cover . (See Figure 11)
Questions? Call Toll Free at 1-800-737-2112
(Continued)
Drain Plug and Washer
Rear Guard
Bolts
EN - 14 Copyright © 2019 MAT Engine Technologies, LLC
Frame Hole
Pan
Figure 10
Spacer
Engine Pulley
Engine Pulley
Cover
Figure 11