HAMPTON BAY HB-7830-02 Guía Para El Uso Y Cuidado página 5

Installation (continued)
Testing the push button and
3
doorbell
Temporarily position the push button (B) and
doorbell (A) where they will be mounted.
Press the push button (B) to verify the
doorbell (A) and push button (B) work properly.
If the doorbell (A) does not sound, move the
doorbell (A) closer to the push button (B) and
test again.
NOTE: Do not permanently mount the push button until
the push button and doorbell are working properly.
4
Mounting the push button
Use either screws (BB) or double-sided tape (EE) to
mount the push button (B).
To mount with screws (BB), remove the back of
the push button (B) by pushing in tab on bottom
with a small screwdriver. Place the push button
(B) back on the door jamb and mark the two
screw holes. Attach with screws (BB) and snap
on the front of the push button (B).
When attaching the push button (B) with
double-sided tape (EE), remove paper from
both sides of the double-sided tape (EE) and
apply to a clean surface.
5
Mounting the doorbell
Use the large screws (CC) to mount the doorbell (A).
Mark two level points 2.75 in. apart on the
mounting surface. Drill two 3/16 in. pilot holes
and insert the wall anchors (DD). Insert the
large screws (CC) into the wall anchors (DD)
leaving about 1/8 in. of the screw threads
exposed. Hang the doorbell (A) on the large
screws (CC) using the keyholes on the back of
the doorbell (A).
NOTE: This doorbell is designed to either hang vertically
or horizontally.
B
A
5
Please contact 1-844-760-3644 for further assistance.
BB
A
DD
CC
HAMPTONBAY.com
A