General Speedrooter 92R Instrucciones De Operación página 8

®
Speedrooter 92R
1. Remove the Feed Roller Assembly by unscrewing and removing
the Feed Roller Axle.
2. For convenience, the components are assembled and wired
together at the factory. Before attempting to install the assembly,
hold the assembly together and remove the wire.
3. While still holding the Feed Roller Assembly together, insert it
into the slot opening of the Carrier.
4. In order to help align the Spacers and Bearings, insert a pencil
point or similar object through the un-threaded end of the Axle
hole in the Carrier. After removing the pencil point, continue to
maintain the alignment of the components.
TROUBLE SHOOTING GUIDE (Table 3)
Problem
Cable kinks or breaks.
Cable tangles in drum.
Drum stops while foot pedal de-
pressed.
Drum turns in one direction but not
other.
Ground fault circuit interrupter trips
and will not reset.
Motor turns but drum does not.
Failure to feed.
See pages 29 - 31 for Parts Lists and Schematic Diagrams.
Probable Cause
Operator forcing the cable.
Too much slack between machine and
drain.
Cable used in wrong size drain line.
Cable exposed to acid.
Operator forcing the cable.
Machine running in reverse.
Hole in pedal or hose.
Hole in diaphragm switch.
Reverse switch failure or momentary
contact switch.
Damaged power cord or extension
cord.
Short circuit in motor.
Faulty ground fault circuit interrupter.
Safety Slip Clutch engaged.
Cable tangled in drum.
Feed misadjusted.
Feed roller frozen.
Worn cable.
5. The Feed Roller Axle should then be inserted through the same
un-threaded Axle hole and should continue to be guided through
the Spacers and Bearings to the threaded Axle hole on the other
side of the Carrier.
6. Securely tighten the Axle to the Carrier with a 3/16" allen wrench.
TANGLED CABLE
If a cable loops over itself in the drum, it will not feed properly. Re-
move and reload the cable to restore function. If the cable kinks, it is
evidence of abuse and results from the use of too much pressure or
use of the wrong size cable for the line. Do not force the cable — let
the cutter do the work.
Solution
Do not force the cable. Let the cutter do the work.
Allow no more than two feet between machine and drain.
A cable that is too large or too small in diameter for a line is
more likely to kink. (Consult Table 1—Cable Applications.)
Clean and oil cables regularly.
Do not force the cable. Let the cutter do the work.
Do not run the machine in reverse to retract the cable from the
drain.
Replace as required.
If no hole found in pedal or hose, replace diaphragm switch.
Replace switch. Note: Momentary contact switch must be held
in position to use reverse.
Replace cords.
Take motor to authorized repair center.
Replace ground fault circuit interrupter.
Do not force cable.
Do not run machine in reverse. Use proper cable size. (Consult
Cable Application Chart—Table 1).
If feed tension knob is too loose the cable will slip. If it is too
tight the feed rollers will wear prematurely.
Clean and lubricate feed rollers regularly. Replace worn rollers.
When cable coils wear flat, cable should be replaced.
8