Troubleshooting Chart - Craftsman 917.25025 Manual De Usuario

TROUBLESHOOTING CHART:
See appropriate section in manual unless directed to Sears service center
PROBLEM CAUSE CORRECTION
iWill not start
1 Out of fuel, 1 Fill fuel tank.
2 Engine not "CHOKED" properly. 2 See "TO START ENGINE" in
Operation section.
Hard to start
Engine will not
turn over
Engine clicks but
will not start
3 Engine flooded.
4 Bad spark plug.
5 Dirty air filter.
6 Dirty fuel filter.
7 Water in fuel,
B Loose or damaged wiring.
3 Watt several minutes before
attempting to start.
4 Replace spark plug,
5 Clean/replace air filter.
6 Replace fuel filter.
7 Empty fuel tank and carburetor,
refill tank with fresh gasoline and
replace fuel filter.
8 Check all wiring.
9 Carburetor out of adjustment.
10 Engine valves out of adjustment.
1 Dirty atr filter.
2 Bad spark plug.
3 Weak ordead battery.
4 Dirty fuel biter.
5 Stale or dirty fuel.
6 Loose or damaged wlring.
7 Carburetor out of adjustment.
9 See "To Adjust Carburetor' in
Service and Adjustments section.
10 Contact a Sears or other quahfied
service center.
t ClearVrep[ace air filter.
2 Replace spark plug,
3 Recharge or replace battery.
4 Replace fuel filter.
5 Empty fuel tank and refill tank witt
fresh, clean gasoline.
6 Check all wiring.
7 See "To Adjust Carburetor" in
Service and Adjustments section.
8 Engine valves out of adjustment.
1 Clutch/brake pedal not depressed
2 Attachment clutch is engaged.
3 Weak or dead battery.
4 Blown fuse.
5 Corroded battery terminals.
6 Loose or damaged wtdng.
7 Faulty Ignition switch.
8 Faulty solenoid or starter.
9 Faulty operator presence
switch(ca).
1 Weak or dead battery.
2 Corroded batten] terminals.
3 Loose or damaged wiring.
4 Faulty solenoid or starter.
31
8 Contact a Sears or other qualified
service center.
1 Depress clutch/brake pedal.
2 Disengage attachment clutch.
3 Recharge or replace battery.
4 Replace fuse.
5 Clean battery terminals.
6 Check all widng.
7 Check/replace ignition switch.
8 Check/replace solenotd or starter.
9 Contact a Sears or other qualified
sentice center.
1 i Recharge or replace battery.
2 Clean batten] terminals.
3 Check all wiring.
4 Checldreplace solenoid or starter.