Important; Reinstalling/Using Washer Again; Transporting Your Washer - Whirlpool 3DWTW3000FW Manual De Uso

WINTER STORAGE CARE
IMPORTANT: To avoid damage, install and store washer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer. If storing or moving
during freezing weather, winterize your washer.
To Winterize Washer:
1� Shut off both water faucets; disconnect and drain water
inlet hoses.
2� Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run
washer on Rinse & Spin cycle for about 30 seconds
to mix antifreeze and remaining water.
3� Unplug washer or disconnect power.

TRANSPORTING YOUR WASHER

1� Shut off both water faucets. Disconnect and drain water
inlet hoses.
2� If washer will be moved during freezing weather, follow
"Winter Storage Care" directions before moving.
3� Disconnect drain from drain system and drain any
remaining water into a pan or bucket. Disconnect drain
hose from back of washer.
4� Unplug power cord.
5� Place inlet hoses and drain hose inside washer basket.
6� Drape power cord over edge and into washer basket.
7� Place packing tray from original shipping materials back
inside washer. If you do not have packing tray, place heavy
blankets or towels into basket opening. Close lid and place
tape over lid and down front of washer. Keep lid taped until
washer is placed in new location.

REINSTALLING/USING WASHER AGAIN

To reinstall washer after non-use, vacation, winter storage,
or moving:
1� Refer to Installation Instructions to locate, level, and
connect washer.
2� Before using again, run washer through the following
recommended procedure:
To Use Washer Again:
1� Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.
2� Plug in washer or reconnect power.
3� Run washer through the Bulky Items cycle to clean
washer and remove antifreeze, if used. Use half the
manufacturer's recommended amount of detergent
for a medium-size load.
11