Woods BATWING BW15.60E Manual De Usuario página 16

Do not attempt to mount a tire unless you have the proper equipment and
experience to perform the job.
Always maintain the correct tire pressure. Do not inflate tires above the recom-
mended pressure. Never weld or heat a wheel and tire assembly. The heat can
cause an increase in air pressure and result in a tire explosion. Welding can
structurally weaken or deform the wheel.
When inflating tires, use a clip-on chuck and an extension hose long enough to
allow you to stand to the side — not in front of or over the tire assembly. Use a
safety cage if available.
Check wheels for low pressure, cuts, bubbles, damaged rims, or missing lug
bolts and nuts.
Never remove split rim assembly hardware (A) with the tire inflated.
A
PROBLEM
Does not cut
Streaks or ragged cut
Excessive side skid wear
Excessive clutch slippage
Vibration
Blades hitting deck
Unit will not raise
Unit doesn't cut level
16 Owner Service
PN 1006348
TROUBLESHOOTING
POSSIBLE CAUSE
Dull blades
Worn or broken blades
Incorrect PTO speed
Ground speed too fast
Drive not functioning (blades do not turn when
PTO is running)
Gearbox malfunction
Excessive clutch slippage
Incorrect blade direction
Broken or worn blades
Attitude incorrect
Ground speed too fast
Excessive cutting height
Excessive lush and tall vegetation
Running with skids continuously on ground
Clutch out of adjustment
Clutch discs worn; wear stops
contacting opposite plate
Blades hitting ground
Broken blade
Bearing failure
Hitch length incorrect
Universal drive
Bent blades or crossbar
Low oil
Wing section cuts lower than
center
Wing section cuts higher than
center
Figure 8
. Split Rim Tire Servicing
CLEANING
After Each Use
●
Remove large debris such as clumps of dirt, grass, crop residue, etc.
from machine.
●
Inspect machine and replace worn or damaged parts.
●
Replace any safety decals that are missing or not readable.
Periodically or Before Extended Storage
●
Clean large debris such as clumps of dirt, grass, crop residue, etc. from
machine.
●
Remove the remainder using a low-pressure water spray.
1.
Be careful when spraying near scratched or torn safety decals or
near edges of decals as water spray can peel decal off surface.
2.
Be careful when spraying near chipped or scratched paint as water
spray can lift paint.
3.
If a pressure washer is used, follow the advice of the pressure
washer manufacturer.
●
Inspect machine and replace worn or damaged parts.
●
Sand down scratches and the edges of areas of missing paint and coat
with Woods spray paint of matching color (purchase from your Woods
dealer).
●
Replace any safety decals that are missing or not readable (supplied free
by your Woods dealer). See Safety Decals section for location drawing.
Sharpen blades.
Replace blades. (Replace in pairs only.)
Set at rated PTO speed.
Reduce ground speed.
Check drive shaft connection.
Check gearbox.
Repair gearbox.
Adjust clutch.
Check to be sure blade edge is correct for direc-
tion of rotation.
Replace or sharpen blades.
Level machine.
Reduce ground speed.
Lower cutting height. (Note: Set height so blades
do not frequently hit ground.)
Recut at 90° to first pass.
Raise cutting height or adjust.
Adjust clutch.
Replace discs.
Raise cutting height.
Replace blades in pairs.
Check gearbox shafts for side play.
Reset hitch length.
Adjust pedestal bearing height to be parallel to
ground.
Replace bent blades or crossbar.
Add hydraulic oil.
Lengthen turnbuckle connecting center yoke to
wing wheel yoke.
Shorten turnbuckle connecting center yoke to
wing wheel yoke.
SOLUTION
MAN1257 (3/23/2018)