Installing The Ink Tanks - Canon imagePROGRAF TM-305 Guia De Instalacion

Installing the Ink Tanks

Install the 5 ink tanks by following the instructions on the screen.
1
Instructions on ink tank installation are
shown on the touch screen. Open the ink
tank covers as instructed by grasping the
handles.
4
Open the pouch and remove the ink tank.
B
• Never touch the ink holes
(A) or metal contacts (B).
Important
Touching these parts may
cause stains, damage the
ink tank, and affect print
quality.
• Avoid dropping the ink
tank after removing it from
the pouch. Otherwise,
ink may leak and cause
stains.
• Do not remove ink tanks to
shake them after they have been
mounted. Doing so may cause ink
to spill.
7
Repeat steps 2 to 6 to install each of the
ink tanks.
2
While pushing the tip of the ink tank lock
lever horizontally, open the ink tank lock
lever upwards.
5
After checking that the color of the ink
tank is the same as the color shown on
A
the label of the printer, insert the ink tank
into the holder as shown in the figure.
Important
8
Close the ink tank covers.
• The BK and MBK ink tanks are
easily mistaken, so be extra careful
with these colors.
6
3
Shake each ink tank gently 1 or 2 times
before opening its pouch.
• Failure to shake the ink tanks
may result in reduced print quality
Important
because ink ingredients have
settled on the bottom of the tank.
• If the ink tank is cold, allow it to
adjust to room temperature before
Note
attaching it to the printer.
6
Close the ink tank lock lever until it clicks.
Be sure to look at
the labels, and check
that the ink tanks are
properly installed.
9
Check that the color of the ink tank that
was set is displayed on the touch screen,
and select OK.
• If the touch screen does not show
the color, repeat steps 2 and 6.
Important