National Restrictions - Klipsch ICON SB 1 El Manual Del Propietario

This device complies with part 15 of the FCC Rules and the applicable Industry Canada
license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
This equipment complies with FCC and IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with mini-
mum distance 20cm between the radiator and your body. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
Cet appareil est conforme à FCC et IC l'exposition aux rayonnements limites fixées pour
un environnement non contrôlé. Cet appareil doit être installé et utilisé avec une distance
minimale de 20 cm entre le radiateur et votre corps. Cet transmetteur ne doit pas être
co-situé ou opérant en liaison avec toute autre antenne ou transmetteur.

NatioNal REstRictioNs

This device is intended for home and office use in all EU countries (and other
countries following the EU directive 1999/5/EC) without any limitation except for
the countries mentioned below:
Country Restriction
Bulgaria None
Outdoor use limited
to 10 mW e.i.r.p
France
within the band
2454-2483.5 MHz
Italy None
Luxembourg None
Norway Implemented
Russian Federation None
Note: Please don't use the product outdoors in France
Manufactured under license from Dolby
Laboratories. Dolby and the double-D symbol are
registered trademarks of Dolby Laboratories.
paCkInG LISt
1. SOUNDBAR
2. WIRELESS SUBWOOFER
3. SOUNDBAR POWER SUPPLY/POWER CORD
4. SUBWOOFER POWER CORD
5. ONE 4.9 FOOT (1.5M) DIGITAL OPTICAL CABLE
6. ONE DUAL RCA CABLE
7. ONE REMOTE CONTROL
8. QUICK SETUP GUIDE
9. SOUNDBAR WALL-MOUNT TEMPLATE
10. THIS OWNER'S MANUAL
Reason/remark
General authorization required for outdoor use and
public service
Military Radiolocation use. Refarming of the
2.4 GHz band has been ongoing in recent
years to allow current relaxed regulation. Full
implementation planned 2012
If used outside of own premises, general
authorization is required
General authorization required for network and
service supply (not for spectrum)
This subsection does not apply for the
geographical area within a radius of 20 km from
the centre of Ny-Álesund
Only for indoor applications
SoUnDbar front
StatUS LIGhtS
SoUrCe
POWER
mUte
AC~100-240V
ON OFF
50/60Hz
90W
VoLUme Up
VoLUme DoWn
SoUnDbar rear
analog rCa Inputs
1 SOURCE
R
L
Digital optical
Cable Input
SUbWoofer rear
SUBWOOFER
VOLUME
MIN MAX
POWER
AC~100-240V
ON OFF
50/60Hz
90W
SUbWoofer StatUS LIGht
bLUe (Solid): Receiving wireless signal from soundbar
reD (Solid): Searching for soundbar wireless signal
1 SOURCE 2
R
L
SoUnDbar StatUS LIGht
reD: In STANDBY ("Sleep") Mode
Green: On Digital Optical Cable Input
oranGe: On Analog RCA L/R Input
Green (flashing): Digital Input muted
oranGe (flashing): RCA Input muted
reD (flashing): Failure to learn a remote
control command
Green or oranGe fLaSheS: A remote
control signal has been received
WhIte (right Status Light):
In 3D Surround Mode
reD and Green (alternating):
Remote programming mode activated
power Supply Input
2
DC IN
24V – 2.5A
65W
OFF
main power
Volume Control
Status Light
main power on/off
power Cord Input
DC IN
POWER
24V – 2.5A
65W
OFF ON
POWER
ON