4.3. USE OF THE RADIATOR
Press the on/standby C key to switch the appliance on/off.
Warning: when the appliance is in standby mode in is anyway powered.
Note: in case of blackout the programming will remain memorised. If the blackout lasts less than 4 min-
utes, the date and time remain memorised and the programming will not be affected.
Note: the icon
indicates that a signal was received from the remote control (optional).
It is possible to select the operating mode among those described above using "Function" key.
For instance, if the comfort mode temperature is at 20.5°C and the day selected is Tuesday (day 2), the
following icons will be displayed:
showing: set temperature, operating mode, time, number of the day of the week.
4.3.1. SETTING OF CURRENT DAY AND TIME
1. Switch the radiator to standby state.
2. Press "-" key and hold it for 3 seconds, the display will show "Set".
3. Use"+" key to select "tEd".
4. When "tEd" is displayed, press function key to confirm your selection.
5. Select the day of the week among 1 (Monday),
2 (Tuesday),... and 7 (Sunday) using "+" and "-" keys.
6. Press function key to confirm your selection.
7. Now the current time is displayed and the figures indicating the time are
flashing;
time can be set using "+" and "-" keys.
8. Press function key to confirm your selection.
9. The figures indicating minutes are flashing; minutes can be set using "+" and "-" keys.
10. Press function key to confirm your selection, the radiator goes back to standby mode.
Note: in case of blackout date and time will remain memorised for about 4 minutes.
4.3.2. PROGRAMMING
1.
Switch the radiator to standby state.
2.
Press "+" key for more than 3 seconds,
"Set" will be displayed.
3.
Use "+" key to select "Prog".
4.
When "Prog" is displayed, press function key to confirm your selection.
5.
Use "+" and "-" keys for each hour of the day, to select the comfort temperature
(full bar in the lower part of the display) or the night temperature (short bar in the lower part of the
display) of day 1 (Monday).
40
EN