Direct Programming Of Intercom Call; Monitor Ringtone Selection - Comelit Group Magis Kit Manual Tecnico

Direct programming of intercom call

Step 1: enter programming mode
Operator 1 and Operator 2 carry out the following procedures on
2 internal units:
1.
2.
3.
» The internal unit emits 1 tone.
» The green LED flashes.
» The internal unit enters audio mode.
» At this point the 2 operators will be communicating with each other.
Step 2: intercom call programming
Operator 1:
» The internal unit manned by operator 1 emits a confirmation tone.
Operator 2:
» The internal unit manned by operator 2 emits a confirmation tone.
Operator 1/Operator 2:
» The internal unit emits 1 tone.
» Programming of the 2 internal units is now complete.
Step 3: programming other internal units
Operator 1/Operator 2:
1.
2.
NOTE
34 34
1.
2.
____
3.
4.
____

Monitor ringtone selection

A
A
A