Hook Up Guide - Monster GreenPower HT 800G PowerCenter Instrucciones E Información De Garantía

ENGLISH

HOOk uP GuIDE

Attach a Monster Power
component's power cord before you plug it into the
appropriate color-coded PowerCenter
Plug each component's power cord (HDTV,
AV receiver, Cable/Satellite box, etc.) into
the PowerCenter's corresponding outlet.
NOTE: The outlets on your PowerCenter are labeled for your convenience. It will not
harm your equipment to plug into an outlet that's labeled differently.
Connecting To Monster GreenPower
Please read these instructions before connecting any equipment to the PowerCenter:
ATTENTION:
1. You must connect an electronic device that draws sufficient power in operational
mode to activate GreenPower switched outlets. If you do not, the GreenPower
switched outlets will not deliver power to connected equipment.
2. Some components can take up to 10 minutes to switch to stand-by or sleep
mode. If the Monster GreenPower
not turn off immediately, please wait approximately 10 minutes to allow the
component plugged into GreenPower Control outlet to switch to stand-by
mode. Once this component is in stand-by mode, the GreenPower switched
outlets will turn off, eliminating energy waste by that component.
identification label to each
®
outlet.
™
switched outlets on your PowerCenter do
™
Outlets
™