Craftsman 536.249810 Manual Del Usuario página 11

OPERATION
HOW TO USE THE GRASS BAGGER
_IL WARNING: Do not ride up or down slopes that are too
steep to back straight up. Never ride the unit across
a slope. See the "Slope Guide" in the back of this
book for information on how to check slopes.
OPERATION
To operate with the grass bagger, follow the steps below.
IMPORTANT: Do not cut wet grass. Wet grass will not
discharge correctly into the grass bagger.
1. Start the engine.
2. Move the throttle control to FAST position.
3. To fill the grass bag, always operate with a slow forward
speed.
4.
If the height of the grass is more than 31/2 inches (9cm), cut
the grass with the mower housing in the highest position.
Then, lower the mower housing and cut the grass again. You
can also cut at 1/2 to 2/3 of the full cutting width of the mower
housing.
HOW TO CLEAR THE CONNECTOR TUBE AND THE
EXTENSION TUBE
if the connector tube or the extension tube becomes filled with
grass, clear as follows.
1. Move the attachment clutch lever to the DISENGAGE posi-
tion (see Figure 13).
2. Move the shift lever to the neutral (N) position.
3. Engage the parking brake (see Figure 14).
4. Stop the engine.
5. Disconnect the retaining clip from the connecting tube
(see Figure 15).
6. Slide the connecting tube toward the rear. To remove grass
or debris, shake the connecting tube.
7. If necessary, remove any grass or debris from the extension
tube.
8. To connect, slide the connecting tube into the extension
tube. Secure the connecting tube with the retaining clip.
Shift Lever Attachment Clutch Lever
/
Figure !3
Clutch/Brake
Pedal
Parking
Brake
Figure !4
Figure !5
F-020902L 11