Innotek BC-50E Guia De Funcionamiento página 3

E. Receptacle cover (BC-200E only) – Fits tightly into the collar receivers charging receptacle. Keeps out water
and dirt. Always keep the receptacle cover in place when the unit is not being charged.
HOW THE NO-BARK COLLAR WORKS
When properly positioned on your dog, the No-Bark Collar will detect the vibrations from your dog's vocal cords
when it barks, howls, or growls. These vibrations are monitored by sophisticated signal processing software
that applies stimulation only when barking occurs. The vibration-sensing function is unaffected by normal dog
activities.
Unlike other anti-bark collars, the Innotek Free Spirit No-Bark Collar has no awkward switches or dials. Just
power it up and put it on your dog according to instructions.
When the unit detects vibration from barking, it administers a brief stimulation. A safety control quiet period (no
barking) of two seconds immediately follows, before additional stimulations are administered As the dog con-
tinues to bark, the stimulation increases in intensity to the appropriate level for that dogs temperament.
Your new Innotek No-Bark Collar features progressive stimulation levels, Level 1 (lowest) to Level 7 (maxi-
mum). With our patented* Auto-Set technology, the No-Bark Collar automatically sets itself at the appropriate
stimulation level that quiets your dog. When your dog first barks, he receives a Level 1 stimulation. A two-sec-
ond learning timeout follows, to give your dog a chance to associate the bark with the stimulation. If your dog
barks again, he will receive a Level 2 stimulation, followed by another timeout. The collar's Auto-Set design
automatically increases the stimulation through as many as seven levels until your dog stops barking.
7
6
5
Levels
4
3
2
1
Time
Auto-Set Stimulation
stimulation will increase to higher levels until the dog stops barking. Your dog will soon learn that the best way
to avoid stimulation is to stay quiet. (Some dogs learn faster than others, so be patient.) Used properly, the No-
Bark Collar will quickly quiet your companion of intermittent nuisance barking.
Sometimes you want your dog to be able to bark, of course. If your dog has a protective role in your home, sim-
ply take the No-Bark Collar off him when you want him to be free to bark.
STEP 1 Adjust the Collar Strap to Your Dog's Neck.
Before installing the battery, adjust the collar so it correctly fits your dog.
1. Use short probes for short-haired dogs; use long probes for long-haired or thick-coated dogs.
2. Place the collar around the dog's neck, so the receiver box is under its chin.
5 minutes
=Barking
The Innotek No-Bark Collar protects your dog from over-stimu-
lation. Let's say that your dog stops barking after receiving a
Level 4 stimulation. After a 5-minute bark-free period, the No-
Bark Collar automatically sets the next stimulation back one
level, in this case Level 3, (one level below the highest level pre-
viously reached). At its next bark, the dog would receive a Level
3 stimulation, a "warning level" that it should recognize.
The Auto-Set feature is fair to the dog. Should it stop barking at
the warning level, it could soon wean itself down to the lowest
level of stimulation. If it barks through the warning level, the
3