WD Plus arendo Manual Del Usuario página 21

5. Button functions
Sealing
Stop
Vacuum & seal
6. LED indicator
Green LED
Red LED
7. Initial use
Take the device out of the package and remove all the packaging material. Place
the vacuum sealer on a level surface and insert the power cord into a properly
installed socket.
Then place a vacuum bag with the open side into the vacuum sealer. Ensure that
the end of the bag touches the plastic tabs of the vacuum sealer. Close the lid
of the device by pushing the lid down with both hands until it locks. Press the
"Vacuum & seal" button to start the vacuum and sealing process. Press the "Seal"
button if you only want to seal the bag. The respective operation is active as long
as the status LED is glowing. Press the left and right unlocking button inwards
to open the lid again subsequently. Press the "Stop" button in the middle of the
device to cancel the respective operations.
English
Starts the sealing function
Cancel all functions /activate standby mode
Starts the vacuum and sealing function
Status LED vacuum packing
Status LED sealing
21