Hilti NCR 060 II-A22 Manual De Instrucciones Original página 12

2. Removing the strap => Remove the battery. Remove the two retaining strap securing screws. Pull the
two retaining strap tabs out of the slots in the base of the tool and remove the retaining strap. Refit the
battery.
5.5 Crimping 5
WARNING
Danger! Risk of fire due to faulty crimping.
▶ Use only cable terminals of the correct type and size for the cable. Failure to observe this point
can result in faulty crimping.
▶ Listen for the signal tone and check that the piston has retracted. If no signal tone is heard or if the
piston does not retract then the crimping is faulty.
WARNING
Risk of injury! Unintentional starting.
▶ Remove the battery before inserting the parts to be connected, i.e. crimped.
1. Open the latch and pivoting bar and insert the connector in the die.
2. Close the pivoting bar and the latch.
3. Insert the battery.
4. Press the control switch.
5. Keep the control switch pressed until the piston has retracted.
6. Open the latch and pivoting bar and remove the connector.
6 Care and maintenance of cordless tools
WARNING
Risk of electric shock! Attempting care and maintenance with the battery fitted in the tool can lead
to severe injury and burns.
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt from the tool.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
Care of the Li­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the cordless tool if signs of damage are found or if parts malfunction. Have the tool
repaired by Hilti Service immediately.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
7 Transport and storage of cordless tools
Transport
CAUTION
Inadvertent starting during transport. Uncontrolled starting during transport may occur if the battery
is fitted, thereby resulting in damage to the tool.
▶ Always remove the battery before transporting the tool.
▶ Remove the battery.
6 English
Printed: 27.07.2017 | Doc-Nr: PUB / 5365804 / 000 / 00