Fitting The Bumper Bar; Removing The Bumper Bar; Adjusting The Seat Unit; Adjusting The Calf Support - Kiddy Evostar 1 Manual De Instrucciones

4.2 Fitting the bumper bar

Slot the bumper bar into the sockets on the seat unit whilst holding
down the release button ( g. 15). Important: Ensure the bumper bar is
locked in place before use by pulling the bumper bar upwards.

4.3 Removing the bumper bar

Press the small buttons on the seat unit under the bumper bar ( g. 16,
no. 1) and pull the bumper bar away from the seat unit ( g. 16, no. 2).
Note: e bumper bar can be released one side at a time to allow easy
access for placing your child in or removing your child from the seat
unit ( g. 17).

4.4 Adjusting the seat unit

Lift the adjustment handle on the top side of the seat unit ( g. 18,
no. 1) and adjust the seat to the desired position ( g. 18, no. 2).
seat unit will lock into position when the handle is released.
Note: e seat unit has 3 positions.

4.5 Adjusting the calf support

Pull the calf support upwards to raise.
Depress both grey buttons at the side of the footrest ( g. 19, no. 1) to
lower into the desired position.
Note: e calf support has 4 positions ( g. 19, no. 2).
4.6 Fitting and removing the sun canopy
Attach and fasten the zip, push the plastic clips rmly onto the seat
unit frame then close the clips ( g. 20). To remove, unfasten the clips
from the seat unit frame and open the zip.

4.7 Using the 5 point safety harness

Fit together the two connectors on the harness straps and push rmly
into the buckle housing until they click together ( g. 21).
Important: Ensure they are fully engaged before use.
As your child grows, the height of the shoulder straps can be altered.
EN
e
11