Binding The Transmitter And Receiver; Battery Safety Guidelines - Carson Reflex Wheel Pro 2,4 GHz Instrucciones

Binding the Transmitter and Receiver

1
1. Turn on the receiver power.
Press the SW switch. The
receiver's LED should start
flashing.

Battery Safety Guidelines

Used correctly, domestic batteries
are a safe and dependable source
of portable power. Problems can
occur If they are misused or abused
– resulting in leakage or, in extreme
cases, fire or explosion. Here are some
simple guidelines to safe battery
use designed to eliminate any such
problems.
Store unused batteries in their packaging and
away from metal objects which may cause a
short-circuit resulting in leakage or, in
extreme cases, fire or even an explosion
Never attempt to recharge ordinary batteries,
either in a charger or by applying heat to
them. They may leak, cause fire or even
explode. There are special rechargeable
batteries which are clearly marked as such.
2
2. Turn on the
transmitter.
Take care to fit your batteries correctly,
observing the plus and minus marks on the
battery and appliance.
Incorrect fitting can cause leakage or, in
extreme cases, fire or even an explosion.
Remove dead batteries from equipment and
all batteries from equipment you know you
are not going to use for a long time.
Otherwise the batteries may leak and cause
damage.
Supervise children if they are replacing
batteries themselves in order to ensure these
guidelines are followed.
CARSON Reflex Wheel Pro 2,4 GHz 50 050 0032
3
3. When the LED on the receiver
becomes solid, the binding
process is completed. The RC
system is ready.
Replace the whole set of batteries at one time,
taking care not to mix old and new batteries
or batteries of different types, since this can
result in leakage or, in extreme cases, fire or
even an explosion.
Never throw batteries in a fire, this can cause
an explosion.
Do not put dead batteries with the normal
household waste. Deliver them at special
collecting institutions.
Make sure battery compartments are secure.
GB
23