Complete The Installation; Mounting The Camera - Honeywell E Serie Guia De Instalacion

Figure 4
Warning
not exceed 25 mA.
3. Set the Auto Iris selector (see
4. Set the Auto Iris lens selector switch to VIDEO for video auto iris lenses.
5. Adjust the back focus using the back focus mounting ring on the front of
the camera. See "Back Focus Adjustment" on page 6.
6. With typical scene illumination, set the ALC Level adjustment
potentiometer for the correct exposure. This can be done visually. More
accurate results will be achieved using a video level meter or
oscilloscope to set the output of the camera to 1 Vp-p.
7. If the scene lighting conditions are extremely uneven, it may be
necessary to adjust the Peak Average potentiometer on the lens. For
more information, please refer to the instructions that came with the
lens.

Complete the Installation

Mounting the Camera

Mounting points are provided on the top and bottom of the camera and are
used to mount the camera on a bracket or tripod. They are designed to
accept standard 1/4-20 mounting bolts.
The mounting bracket must be capable of supporting the weight of the
camera and its lens. In cases where the lens is substantially heavier than the
camera, it is better to use the mounting point on the lens itself.
Rev 1.01
Connector Pinouts (Video Drive)
Pin # Video drive
1
2
3
4
The maximum load for this type of lens must
Figure
9
+12 VDC
NC
Video
GND
1) to AI.
Document 900.0350
05/05