Important Remarks - Cardin TXQ504C2 Manual Del Usuario

Radiomando digital con display lcd y funcionalidad

Ocultar thumbs

Contenido

página de 81

/ 81
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

• The use and installation of these appliances must rigorously respect the indications supplied by the manufac-

turer. The manufacturer accepts no liability for damage caused by, or situations arising from, the improper use of

these appliances.

Attention! Only for EU customers - WEEE marking.

This symbol indicates that once the products life-span has expired it must be disposed of separately from other rubbish. The

user is therefore obliged to either take the product to a suitable differential collection site for electronic and electrical goods

or to send it back to the manufacturer if the intention is to replace it with a new equivalent version of the same product.

Suitable differential collection, environmental friendly treatment and disposal contributes to avoiding negative effects on the ambient

and consequently health as well as favouring the recycling of materials. Illicitly disposing of this product by the owner is punishable

by law and will be dealt with according to the laws and standards of the individual member nation.

USE

This radio control device allows the remote activation of electrical and electronic appliances with its best use

in the following areas: automatic opening systems, alarm systems and multiple access systems (apartment

blocks etc.) The receiver has been designed for multiple access with up to 3000 users each of which may

be memorised or cancelled individually. The code is memorised in the receiver via radio. Each code is stored

in a memory location which can activate up to 4 functions. 1 transmitter = 4 functions max. = 1 location;

3000 users = 12000 functions max.

Transmitters 433 MHz

TXQ504C2

TXQ504C4

Receivers 433 MHz

RCQ504-3G

RCQ504-3G10

RCQ504-WF

Memory module

This is extractable, furnished with a non-volatile EEPROM 24LC256 - 3000-code memory type (the receiver

can also be used with the 1000-code 24LC64 module present in the RCQ504D00 receiver) that contains the

transmitter codes. It is possible to move the memory module to another receiver, maintaining all the functions

without having to reprogram the other receiver.

The programmed codes are maintained in this module even in the absence of power without a time limit.

Attention! Removing and inserting the memory module must be carried out when the receivers are switched

off otherwise the memory content could become corrupt.

Receiver antenna: The installation of the antenna is fundamental, connected to the receiver it represents the

reception point for the radio control.

A tuned antenna ANS400 (433 MHz) / ANQ800-1 (868 MHz) using a coaxial cable RG58 (impedance 50Ω)

with a maximum length of 15 m must be installed between binding posts 19-20. The antenna should be

positioned out of doors in the highest possible point, visible and away from metal structures.

3G/WF Antenna: The antenna for the 3G/WF card, which is a specific card supplied along with the product, must

always be installed. It should be screwed to the dedicated connector on the upper part of the box (see fig. 2).

Antenna extension:

location using an accessory. The accessory consists of a cable in two different lengths and a holding bracket

for installing the antenna to the wall. The accessory is available in the following formats:

- antenna extension with a 5-metre cable ANSKITGSMWF5 / 5-metre cable ANSKITGSMWF10