Placing The Child In The Seat - JANE DRIVE Manual De Instrucciones

The booster seat can be secured with the ISOFIX anchors, this
gives the seat greater lateral stability.
To install it follow the steps below:
• Extract the ISOFIX anchors (6) by turning the handle (9) found
7
on the front of the base. .a
• Guide both anchors towards the ISOFIX connection points of
your vehicle and press until both sides are locked in place. Two
green indicators on the sides of the base (8) will confirm that
they are correctly locked in place. If one or both or the indica-
7
tors are red, try again. .b
• Turn the handle (9) the other way to adjust the safety seat so it
is positioned firmly against the backrest of the vehicle seat.
• Lengthen the Top Tether strap (14) until it reaches the ring in
1
the vehicle and hook it on. .d
• Tighten the strap by pulling the end until a green indicator ap-
pears on the Top Tether tightener.
Removing the booster seat when it has been installed with ISO-
FIX and the Top Tether strap:
• Loosen the Top Tether by pressing the button on the tightener.
1
.e. The indicator on the tightener will display a red line. Re-
7
.c
1
.e
lease the hook from the ring of the vehicle.
• Loosen the tension of the ISOFIX anchors by turning the han-
dle (9).
• Release the ISOFIX anchors by pressing both release buttons
(7). The indicators on the side (8) will turn red.
• Take the booster seat out of the vehicle. The ISOFIX anchors
can be stored inside the base by turning the handle (9).
L. PLACING THE CHILD IN THE SEAT
• Place the child in the booster seat, insert the shoulder belt of
the vehicle through the belt guide on the side of the headrest
5
(11). .a
• Pass the seat belt over the child and fasten the buckle.
• PLastly, pass both parts of the belt under both armrests (10).
NOTE: Always remember to secure the child with the seat belt
!
fastened correctly. The belt should fit snugly, and must not
be twisted, and should hold the pelvis area (lap belt) and the
shoulders (torso belt) secure.
5
.b
5
.c
EN 49