Lanaform Aqua Relax Manual Del Usuario página 5

INSTRUCTIONS
REMOTE CONTROL FUNCTIONS
1 A
Power control button
B
Time control button
C
Programme control button
D
On/O button
CHANGING THE REMOTE CONTROL BATTERY
The remote control uses a 3V CR2032 battery (provided with the device).
• To change the battery, use the right sized athead screwdriver (not provided).
• Position the end of the screwdriver in the slot in the back of the remote control.
• Turn the screwdriver anti-clockwise (follow the arrow) until the beginning of the arrow is next to the open padlock symbol ( g.: 2).
• Remove and change the battery and repeat the process in reverse to close the battery compartment.
REMOTE CONTROL HOLDER
The remote control is supplied with a holder that you can use to keep the remote control handy when you are using your AQUA RELAX. This accessory comes with
a suction pad so you can x it to the wall, avoiding the risk of the remote control falling into the water. This makes it easy to use your mat without getting out of
the bath.
To remove the holder from the wall, you should pull the tab ( g.3, point E) on the holder ( g.3, point F) so as not to damage it and retain its suction power.
MAIN UNIT FUNCTIONS
4 G
Time control button
H
Programme control button
I
Power control button
On/O button
J
POSITIONING INSTRUCTIONS
The main unit can either be positioned on a stable surface in the bathroom or can be xed to the wall to guarantee complete electrical safety.
N.B.: if you have any concerns about the correct positioning or xing of the device to the wall, always consult a quali ed electrician.
INSTALLING THE MAIN UNIT
IMPORTANT
You can always position the main unit on a stable surface in the bathroom.
If you want to x it to the wall, we would recommend that it is positioned vertically.
The main unit should under no circumstances be xed or positioned less than 60cm from your bath or somewhere where it could fall into the bath, washbasin etc.
INSTALLING THE MAIN UNIT
If you decide to x the main unit to the wall:
1. The main unit should be hung with the air pipe outlet pointing downwards ( g.5 point L).
2. Once you have marked the two positions for the holes on the wall, drill 2 holes 5 mm wide and 28 mm deep, taking care not to pierce any electrical cables or
water or gas pipes that might be set into the wall.
3. Press the rawlplugs (provided) into the holes and screw in the 2 screws provided, leaving around 7 mm showing.
4. Position the main unit so that the screw heads t into the round "keyhole" shaped holes on the back of the device ( g.5 point K)
5. Make sure that the main unit is xed securely on the screws.
N.B. You might need to adjust the depth of the screws to make sure the device is xed safely and securely. For cavity or half-timbered walls, special xing systems
(not provided) might be needed.
If you decide not to x the main unit to the wall:
1. Make sure that the main unit is positioned on a stable surface to avoid any risk of it falling over.
2. Make sure it is not positioned near the washbasin, and make sure that it is at least 60cm from your bath or somewhere where it might get damaged.
Aqua Relax
EN
5