Troubleshooting - Remington BS1812A Manual Para El Usuario

TROUBLESHOOTING

WARNING:
fi re, electrical shock or rotating line.
Note: For additional help, visit our technical service web site at www.desatech.com.
OBSERVED FAULT
Trimmer/Edger does not start wen you
squeeze the trigger.
Trimmer/Edger runs slowly or stalls
easily.
Line does not feed when you tap the
line advance button.
Battery discharges quickly.
Battery not charging.
Remove battery before servicing. Severe injury or death could occur from
POSSIBLE CAUSE
1. Battery not installed properly.
2. Battery not charged.
3. Trigger lockout button not
depressed prior to squeezing trigger.
1. Battery is nearly depleted.
1. All the line has been used on spool.
2. Line has retracted into spool.
3. Line is caught or tangled on spool and
will not feed.
1. Battery not fully charged.
2. Battery worn and will not hold
charge.
1. Charger not plugged in.
2. Battery not fully inserted into charger
base.
3. Charger cord not properly connected
to charger base.
4. Charger damaged.
SAVE THESE
INSTRUCTIONS
REMEDY
1. Verify proper installation of bat-
tery.
2. Insure battery is charged per re-
quirements.
3. Follow directions outlined in basic
trimmer operation.
1. Recharge battery completely.
1. Install new line on spool.
2. Remove spool and pull line out,
then replace spool.
3. Remove spool, loosen and un-
tangle line, then replace spool.
1. Recharge battery completely.
2. Replace battery.
1. Plug charger into 120V 60Hz AC
source.
2. Insure battery is inserted correctly
in charger base.
3. Insure charger cord is fully inserted
into charger base.
4. Replace charger.
15 www.desatech.com