Magic Chef MCSDRY1S Manual De Usuario página 8

4 Install the wall-mounting hooks to the
wooden slats installed in the previous step.
Using the (4) 1" Phillips head screws
included, affix the mounting hooks to the
wooden slats as shown in the diagram to
the right.
5 Install the exhaust connector as shown
in the illustration using the (3) ½" long
Phillips round head screws included.
sections (1) pointing downward.
sections (2) pointing upward
6 Install the lower wall spacers (included)
using the (2) ½" long Phillips flat head
screws (included).
These spaces are required when installing
the unit on the wall to allow the necessary
ventilation for efficient operation.
Failure to install the spacers will both
reduce the ventilation needed to operate
your unit as well as put the appliance in
a tilted position on the wall which could
present a possible unstable wall installation.
7 Mounting the dryer to the wall hanging
assembly.
With the assistance of a 2nd person, lift
the dryer and align the mounting holes
at the rear of the dryer with the mounting
hooks.
Tilting the dryer to a 45° angle, insert the
hanging brackets into the mounting holes on
the dryer as shown in the figure to the right.
Once the dryer mounts are in place,
slowly lower the dryer in place and
check all installation points for stress or
weakened contact.
21 ¾"
Mounting Hooks
Wooden Slat
Section 1
Exhaust Connector
Section 2
Exhaust Connector
Wall
Spacers
½" Phillips Flat Head Screws
EN-8
1" Phillips Head Screws