Taurus Artica 2600 Manual De Instrucciones página 17

the iron, while turning the temperatu-
re regulator of the iron in a clockwise
direction. (Fig 2)
- Move the iron in a top to bottom
direction while pressing the steam
control (B). Important: for cotton and
linen, its recommended to put the
iron base in contact with the material.
For other more delicated fibres, it's
recommended to keep the iron base
at some centimetres of distance.
Once you have finished using the
appliance:
- Select the minimum position (MIN)
using the thermostat control.
- Unplug the appliance to the mains.
- Remove the water from the water
tank.
- Clean the appliance
Cleaning
- Disconnect the appliance from the
mains and let it cool before underta-
king any cleaning task.
- Clean the equipment with a damp
cloth with a few drops of washing-up
liquid and then dry.
- Do not use solvents, or products
with an acid or base pH such as blea-
ch, or abrasive products, for cleaning
the appliance.
- Do not submerge the appliance in
water or any other liquid, or place it
under a running tap.
Self-cleaning function:
- It is important to self-clean the
appliance at least once a month to
remove calcium and any other built-
up minerals inside the iron.
- Fill the depository to its maximum
level, as indicated on "water fill"
section.
- Place the iron in a vertical position,
plug in to the mains m and select the
maximum temperature.
- Leave the appliance to heat up until
the pilot light indicates that it has
reached its consigned temperature.
- Unplug the appliance and place in
the sink.
- Press the self-clean button, and
keep it pressed down.
- Let the water flow out through the
steam vents in the base, while lightly
shaking the appliance.
- Release the button after a minute or
when the tank becomes empty.
- Leave the iron in the vertical posi-
tion until it has cooled.
Anomalies and repair
- Take the appliance to an authorised
technical support service if problems
arise. Do not try to dismantle or repair
without assistance, as this may be
dangerous.
- If the connection to the mains has
been damaged, it must be replaced
and you should proceed as you would
in the case of damage.
For EU product versions and/or in
case that it is requested in your
country: