Teamtex L13 Manual Del Usario página 18

Put the headrest of the car seat at its lowest position. Fold the Top Tether strap over the back of
the car seat so that it does not get trapped during installation (6). Extend the ISOFIX/EASYFIX
connectors from the car seat as far as possible by pulling simultaneously on the red handle on
the base and the red ISOFIX/EASYFIX system strap (7).
Position the car seat on the rear seat of the vehicle bring the ISOFIX/EASYFIX connectors in
line with the seat's ISOFIX anchor points (8). Click the ISOFIX/EASYFIX connectors into the
anchor points; the indicators on each connector should turn from red to green (9). Release
the safety catch of the ISOFIX/EASYFIX system by pulling the red handle attached to the base
and gently pushing the car seat (10). With the safety catch released, push the car seat by
exerting equal pressure on both sides until the rear of the car seat is pressed firmly against
the vehicle seat.
Bring the Top Tether strap over the vehicle seat and attach the clasp to the vehicle's Top Tether
anchor point (11).
Depending on the make of your car, the additional Top Tether anchor point may be located:
• Behind the rear seat of the vehicle.
• On the floor to the rear of the vehicle.
• On the ceiling to the rear of the vehicle.
Please refer to your car user manual to locate the additional Top Tether anchor point. Never
attach the Top Tether to a point that is not recommended by the vehicle manufacturer. Never
alter the vehicle yourself in order to try and fasten the Top Tether (for example by piercing,
screwing or attaching an anchor point yourself ).
Push the car seat against the back of the vehicle seat and pull on the loose end of the Top
Tether strap. When the belt is fully tightened, the indicator on the Top Tether strap will turn
from red to green (12).
Open the buckle of the harness by pressing on the red button in the centre of the buckle (13).
Sit your child in the car seat. The lifting armrests make it easier for you to seat the child and
to put on the harness.
To close the harness, join together both ends of the shoulder straps and slide them into the
buckle harness. You should hear it click (14).
Tightening the harness: Pull on the adjusting straps located on the harness. You do not
•
need to press on the adjuster buttons (15).
gerous. You should not be able to slide more than two fingers between the shoulder strap
and the child's chest.
Loosening the harness: Press on the adjuster buttons located on the upper part of the
•
harness, while pulling at the same time on the lower harness sections (16). Press on the red
harness buckle button to free your child completely.
Some ISOFIX car seat models are fitted with a buckle that sets off an audible alarm (available
as an option). This alarm warns the parents if the child opens the buckle at an inopportune
moment during the journey.
IMPORTANT: Before each journey, check that the armrests have been lowered. A properly
18
User guide
IMPORTANT: A poorly fitting harness can be dan-