NuTone 765HFL Manual De Instrucciones
Ocultar thumbs Ver también para 765HFL:

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

VENTILATION FAN
WITH HEATER & FLUORESCENT LIGHT
READ AND SAVE THESE INSTRUCTIONS
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-
JURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer at the address
or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel. Lock or tag service panel to prevent power from being
switched on accidentally.
3. Installation work and electrical wiring (including switch location)
must be done by a qualified person(s) in accordance with all
applicable codes and standards.
4. Provide sufficient air for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment
to prevent backdrafting. Follow the combustion equipment
standards such as those published by the National Fire Pro-
tection Association (NFPA), the American Society for Heating,
Refrigeration and Air Conditioning Engineers (ASHRAE), and
local codes.
5. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. Provide a separate 20 AMP circuit. Use 12 GA., 90
power cable which meets code.
8. Do not use a speed control with this product.
9. This unit must be grounded.
CAUTION
1. For general ventilating use only. Do not use to exhaust hazard-
ous or explosive materials and vapors.
2. THIS PRoDUCT MUST BE MoUNTED IN A FLAT CEILING
oNLy. Installations in ceilings 9-feet high or less will provide
maximum comfort. DO NOT MOUNT THIS PRODUCT IN A
WALL.
3. Install in ceiling only - at least 6 inches from any wall.
4. To avoid motor bearing damage and noisy, unbalanced impel-
lers, keep drywall spray, construction dust, etc. off motor and
impeller.
5. Read specification label on product for information and require-
ments.
CLEANING & MAINTENANCE
For quiet and efficient operation, long life, and attractive appear-
ance - lower or remove grille and vacuum interior of fan with a
dusting brush attachment.
The motor is permanently lubricated and never needs oiling. If
the motor bearings make excessive or unusual noise, replace
the motor with the exact service motor. The impeller should also
be replaced.
Replace light bulb with a 27-Watt, 3500K (maximum) GU24
fluorescent lamp.
REGISTER YOUR PRODUCT ONLINE AT
www.nutone.com/register
OPERATION
Use a 3-Function Control to operate the heater, fan, and light
separately. See "Connect Wiring" for details.
WARRANTY
Broan-NuTone warrants to the original consumer purchaser of its products that such products
will be free from defects in materials or workmanship for a period of one year from the date
of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE.
During this one-year period, Broan-NuTone will, at its option, repair or replace, without
charge, any product or part which is found to be defective under normal use and service.
THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS AND
TUBES. This warranty does not cover (a) normal maintenance and service or (b) any
products or parts which have been subject to misuse, negligence, accident, improper
maintenance or repair (other than by Broan-NuTone), faulty installation or installation
contrary to recommended installation instructions.
The duration of an implied warranty is limited to the one-year period as specified for the
express warranty. Some states do not allow limitation on how long an implied warranty
lasts, so the above limitation may not apply to you.
BROAN-NUTONE'S OBLIGATION TO REPAIR OR REPLACE, AT BROAN-NUTONE'S
OPTION, SHALL BE THE PURCHASER'S SOLE AND EXCLUSIVE REMEDY UNDER
C minimum
o
THIS WARRANTY. BROAN-NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, CON-
SEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH
PRODUCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights, which
vary from state to state. This warranty supersedes all prior warranties.
To qualify for warranty service, you must (a) notify Broan-NuTone at the address or telephone
number stated below, (b) give the model number and part identification and (c) describe
the nature of any defect in the product or part. At the time of requesting warranty service,
you must present evidence of the original purchase date.
Broan-NuTone LLC Hartford, Wisconsin www.nutone.com 888-336-3948
Installer: Leave this manual with
TYPICAL INSTALLATION
Housing mounted to joists, trusses, or I-joists.
BROAN-NUTONE ONE YEAR LIMITED WARRANTY
the homeowner.
CEILING
JOIST, TRUSS,
OR I-JOISTS
CEILING
MATERIAL
Up to 24-inches on-center.
MODEL 765HFL
Page 
POWER
MOUNTING
CABLES
CHANNELS
HOUSING
GRILLE

Publicidad

Tabla de contenido
loading

Resumen de contenidos para NuTone 765HFL

  • Página 1 This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties. To qualify for warranty service, you must (a) notify Broan-NuTone at the address or telephone CAUTION number stated below, (b) give the model number and part identification and (c) describe the nature of any defect in the product or part.
  • Página 2 MODEL 765HFL Page 2 PLAN THE INSTALLATION * SCREW (2) HoLE FoR oPTIoNAL SCREW MoUNTING (4) INSULATIoN (Can be placed RooF around and over CAP housing.) BoTToM EDGE NAIL (4) oF FRAMING 2. Mount housing. Extend hanger bars to the width of the framing. Hold fan in place with the hanger bar tabs wrapping around the bottom edge of the framing. HoUSING Nail fan to framing or fasten with screws (not provided) 4-IN.
  • Página 3 MODEL 765HFL Page  CONNECT WIRING INSTALL GRILLE & BULBS LIGHT 8. Plug-in & HEAT light. VENTILATOR HOUSING BLACK to RED (Heat) Hold grille RED to BLUE (Light) assembly up near BLACK to BLACK housing. Connect (Fan) light plug from WHITE to WHITE WHITE to WHITE...
  • Página 4: Service Parts

    MODEL 765HFL Page 4 12. Rotate heater grille. Use a flat-bladed screwdriver to rotate the round heater grille to provide heat in the desired direction. SERVICE PARTS Key No. Part No. Description 1 97017572 Housing Assembly 2 97017712 Slide Mounting Channel RH (2 req) 3 97017711 Slide Mounting Channel LH (2 req) 4 97016449 Duct Connector Assembly, 4” 5 98010407 Electrical Knockout Panel 6 99170245 Screw, #8-18 X .375” * (5 req)
  • Página 5: Funcionamiento

    Esta garantía reemplaza a todas las garantías anteriores. Para tener derecho al servicio de garantía, usted debe (a) notificar a Broan-NuTone a la dirección PRECAUCIÓN o al número de teléfono indicado abajo, (b) indicar el número de modelo y la identificación de la...
  • Página 6: Instalación

    MODELO 765HFL Página 6 PLANEACIÓN DE LA TORNILLO (2) ORIFICIO PARA MONTAJE OPCIONAL CON TORNILLO (4) INSTALACIÓN AISLAMIENTO (puede ponerse alrededor y sobre TAPA DE la cubierta) TECHO * BORDE INFERIOR DE LA ESTRUCTURA CLAVO (4) 2. Monte la cubierta.
  • Página 7: Conexión Eléctrica

    MODELO 765HFL Página  CONEXIÓN ELÉCTRICA INSTALE LA REJILLA Y LAS BOMBILLAS CALOR VENTILADOR CUBIERTA DEL VENTILADOR NEGRO con 8. Conecte ROJO (calor) ROJO con la luz. AZUL (luz) NEGRO con Sostenga el conjunto NEGRO (ventilador) BLANCO con de la rejilla cerca de...
  • Página 8: Piezas De Repuesto

    MODELO 765HFL Página  12. Gire la rejilla del calefactor. Con un destornillador plano, gire la rejilla del calefactor redonda para proporcionar calefacción en la dirección deseada. PIEZAS DE REPUESTO Clave No. Pieza No. Descripción 97017572 Conjunto de la cubierta...

Tabla de contenido