Publicidad
This instruction sheet covers the installation of the NV-P20-XX models listed above. The Nuvo P20 keypad provides instant access to core features
EN
such as volume control, mute, skip tracks, play / pause and access to the top 5 favorites without needing to use the app on a phone or tablet. This
keypad features capacitive touch control and is fully backlit with white LED. The Nuvo P20 keypad is powered by a single 802.11af POE (Power Over
Ethernet) connection that would be supplied from a compatible POE switch or injector.
Adding a Keypad to the Nuvo Player System
This installation assumes the Player Portfolio system is already installed. If not, please refer to the Player Portfolio manual to install all of the zones before
keypads are added. Once all the zones have been added follow the steps below to bind a keypad with a zone.
Important: The P20 Keypad requires a single Power Over Ethernet (802.11af POE) connection and needs to be connected to the same network, or subnet,
of the zone it is intended to control.
Fig. 3 / Fig. 3 / Abb. 3 / Fig. 3 / Fig. 3 / Fig. 3
STEP 1: Navigate to the Settings menu by pressing the gear icon at the bottom of the home page (Fig. 3).
STEP 2: Select "Add a component" (Fig. 4).
STEP 3: Select "Keypad" (Fig 5).
Fig. 6 / Fig. 6 / Abb. 6 / Fig. 6 / Fig. 6 / Fig. 6
STEP 4: Look for the LEDs to have a breathing motion. If the LEDs are not breathing, select "The LED's are not breathing" at the bottom of the screen
(Fig. 6 & Fig 7). If the LED's are breathing, select "Next" (Fig 8).
Fig. 4 / Fig. 4 / Abb. 4 / Fig. 4 / Fig. 4 / Fig. 4
Fig. 7 / Fig. 7 / Abb. 7 / Fig. 7 / Fig. 7 / Fig. 7
2
Fig. 5 / Fig. 5 / Abb. 5 / Fig. 5 / Fig. 5 / Fig. 5
Fig. 8 / Fig. 8 / Abb. 8 / Fig. 8 / Fig. 8 / Fig. 8
Publicidad
