Heavy Duty Metal Rack Shelving Installation Instructions; Shelving Use Requirements; Unpack; Assemble & Complete - Gladiator GARA904X Serie Instrucciones De Ensamblaje

HEAVY DUTY METAL RACK SHELVING

Shelving Use Requirements

All Rack Shelf Sizes: Maximum weight limit is 2,000 lbs (907 kg)
for each shelf, not to exceed 8,000 lbs (3,628 kg) for the entire
shelving unit.

Unpack

WARNING
Excessive Weight Hazard
Use two or more people to move and assemble
shelving.
Failure to do so can result in back or other injury.
NOTE: Use two people to assemble shelving and to move it.
1. Remove and verify the contents. See the "Parts" section to
sort out all of the parts.
2. Dispose of/recycle all packaging materials.
Assemble & Complete
No tools or hardware required.
■

IMPORTANT:

Use two people to assemble shelving and to move it.
■
Determine shelf spacing before assembly.
■
NOTE: It is recommended to space the shelves equally from
top to bottom of the shelving unit and build it from the bottom
up. See the "End Frames/Support Beams" illustration.
Prior to assembly, refer to the sticker located on the bottom
■
of one of the welded-end frame assemblies (P4) and record
model and serial numbers on the included warranty page.
There are many benefits of registering the product. Find out
more and register the product online at
www.gladiatorgarageworks.com.
In Canada, contact your Whirlpool Canada LP designated
service company or call 1-800-807-6777.
INSTALLATION INSTRUCTIONS
Support Beam Orientation
End Frames/Support Beams
P4
P2
P2-Support beams (8)-4 in front, 4 in back
P4-Welded-end frame assemblies (2)
NOTES:
It is recommended to put the first shelf in slots 1 and 2 from
■
the bottom, the second shelf in slots 8 and 9 from the bottom,
the third shelf in slots 9 and 10 from the top, and the fourth
shelf in slots 1 and 2 from the top. Keep two of the shelves on
the bottom half of the shelving rack.
The tie channel supports (P3) provide load support and
■
structural integrity.
All tie channel supports (P3) must be assembled as shown in
■
the "Tie Channel Support Assembly" illustration.
P2
P2-Support beams
5