Cleaning And Maintenance - Termozeta frullatore glass Libro De Instrucciones

• Connect the plug to the electrical outlet.
• Operate the appliance at the desired speed using the control (1)
• After use turn off the appliance by setting the control (1) to position 0, wait until the blades
have completely stopped before removing the lid (4) and disconnect the plug from the outlet
ADVICES
• The solid ingredients (fruits, vegetables ...) must be cut into cubes, approximately 2x2 cm
in size, before being introduced into the glass.
• Before operating the appliance, pour in the glass half of the liquids included in your recipe
(e.g., milk, soup ...) and add the remaining half during processing.
• Switch on the appliance starting from the lowest speed and complete the processing at
higher speed.
• To incorporate more air into your preparation, use the P function (pulse operation).
POSITION
0
1
2
P

CLEANING AND MAINTENANCE

WARNING
!
Before performing any cleaning, disconnect the plug from the electrical outlet.
• Clean the appliance body (2) with a slightly damp soft cloth. Do not immerse it in water
or other liquids.
• Remove the blade holder (6) from the jar (5) by turning clockwise and pull the blades (7)
being careful as they are sharp.
• Wash the lid (4), the jar (5), the blade holder (6) and the blades (7) with warm water and a
normal dishwashing detergent,
they are very sharp.
• Never use chemicals or abrasives.
• To reassemble the jar unit proceed as follows:
- insert the blades (7) in the holder.
- screw the support (6) to the jar (5) by turning it counterclockwise.
Lange Distribution S.r.l. reserves the right to introduce technical
and/or aesthetic changes to its products intended to improve performances.
Termozeta is an international trademark. Copyright © 1995. All rights reserved.
Lange Distribution S.r.l. - Via Treviso, 35 - 20127 Milano – Italy
ENGLISH
Low speed - Continuous operation
High Speed - Continuous operation
High speed - Pulse operation - Manual operation Releasing the control
the appliance will stop automatically
paying close attention to the blades located in the glass as
Operation
Appliance switched off
(control return to "0")