IDC Mikro Modo De Empleo página 37

To remove the collet:
▷ Apply the spindle wrench to the collet.
Fig. 11
▷ Insert a milling tool into the open collet.
▷ Using the spindle wrench, unscrew the collet out
of the spindle.
Fig. 12
▷ Clean the collet holder.
The collet holder must be free of shavings/chips
and debris.
Fig. 13
C L E A N I N G A N D M A I N T E N A N C E
▷ Clean the inside of the collet with the fine collet
brush.
Fig. 14
NOTE:
Only use the provided collet grease when main-
taining the collet cone.
▷ Apply a slight coat of collet grease to the
threads of the collet.
▷ Screw the cleaned and lubricated collet in
reverse order to the stop back into the spindle.
CAUTION:
Danger of tool breakage!
▷ Make sure to remove the milling tool from the
collet chuck!
When the milling tool was from the milling
machine tool holder:
▷ Place the tool properly positioned back into the
tool holder.
Maintenance unit
▷ Visually check the service unit for:
▪ Visible particles, debris or particulate matter
within the acrylic glass (signs for contami-
nated compressed air)
▪ Amber discolouration of the filter element
(sign of oil in the compressed air)
▪ Water in the filter (sign of water in the com-
pressed air)
E N
37