Warnings - Graco 127643 Manual De Instrucciones

WARNINGS

E.1
EN
The following warnings are for the setup, use, grounding, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to
procedure-specific risks. When these symbols appear in the body of this manual or on warn-
ing labels, refer back to these Warnings. Product-specific hazard symbols and warnings not
covered in this section may apear thoughout the body of this manual where applicable.
FIRE AND When flammable fluids are
EXPLOSION present in the work area,
such as gasoline and wind-
shield wiper flui , be aware
that flammable fumes can
ignite or explode. To help
prevent fi e and explosion:
EQUIPMENT Misuse can cause death or
MISUSE serious injury
!
Burn Equipment surfaces and
Hazard
fluid that is heated can
become very hot during
operation
4
WARNING
Use equipment only in will ventilated area.
Eliminate all ignition sources, such as cigarettes
and portable electric lamps.
Keep work area free of debris, including rags
and spilled or open containers of solvent and
gasoline.
Do not plug or unplug power cords or turn
lights on or off when flammable fumes are
present.
Ground all equipment in the work area.
Stop operation immediately if static spark-
ing occurs or if you feel a shock. Do not use
equipment until you identify and correct the
problem.
Keep a working fi e extinguisher in the work
area.
Do not operate the unit when fatigued or un-
der the influen e of drugs or alcohol.
Do not exceed the maximum working pres-
sure or temperature rating of the lowest rated
system component. See Technical Data in all
equipment manuals.
Use fluids and solvents that are compatible
with equipment wetted parts. See Technical
Data in all equipment manuals. Read fluid and
solvent manufacturer's warnings. For com-
plete information about your material, request
MSDS from distributor or retailer.
Do not leave the work area while equipment is
energized or under pressure.
Turn off all equipment when equipment is not
in use.
Check equipment daily. Repair or replace worn
or damaged parts immediately with genuine
manufacturer's replacement parts only.
Do not alter or modify equipment. Alterations
or modific tions may void agency approvals
and create safety hazards.
Make sure all equipment is rated and approved
for the environment in which you are using it.
Use equipment only for it intended purpose.
Call your distributor for information.
Route hoses and cables away from traffi areas,
sharp edges, moving parts, and hot surfaces.
Do not kink or over bend hoses or use hoses to
pull equipment.
Keep children and animals away from work area.
Comply with all applicable safety regulations.
To avoid severe burns do not touch hot fluid or
equipment.
M0309