Eldes EWF1 Manual De Uso página 14

In order to avoid fire or explosion hazards, the system must be used only with approved bat-
tery. Special care must be taken when connecting positive and negative battery terminals.
Dispose old batteries only into special collection sites. Do not charge, disassemble, heat or
incinerate old batteries.
The battery status can be monitored in real-time using ELDES Utility software.
The system sends an SMS message to the listed user phone number as soon as the battery
level runs below 5%.
We strongly recommend using EvE CR9v-P, Energizer LA522 or Ultralife U9vL-J 6f22
battery.
4.4 RESTORING THE DEFAULT PARAMETERS
1. Remove the battery from EWf1/EWf1CO.
2. Press and hold the RESET button.
3. Insert the battery back to EWf1/EWf1CO.
4. Hold the RESET button until you hear a short beep.
5. Release the RESET button.
5. EWF1/EWF1CO ZOnE anD taMPEr
Upon successful device pairing process, the system adds wireless zone (-s) as follows:
• EWF1 - 1 fire-type zone intended for smouldering fire/smoke detection.
• EWF1CO - 1 fire-type and 1 CO-type zone intended for smouldering fire/smoke detection and
carbon monoxide detection respectively.
In case of tamper violation, the alarm is caused regardless of system being armed or disarmed.
There are 2 ways to detect tamper violation on EWf1/EWf1CO:
14
EN EWF1-EWF1CO