Eden World Tour Serie Guia De Inicio Rapido página 15

24. Bridged mono indicator: Illuminates when bridged mono
mode is activated.
25. Phones: Plug your headphones in to your amplifier here,
alternatively this connection can be used to take a signal to
another amplifier.
WT800 Back Panel Navigation:
1. Speakon output (Left Amplifier): Connect your amplifier to a
single speaker cabinet.
2. Speaker output 1 (Left Amplifier): Connect your amplifier to
a speaker.
3. Speaker output 2 (Left Amplifier): Connect your amplifier to
a second speaker.
4. Speakon output (Bridged mono mode only): Connect your
amplifier to a single speaker cabinet.
5. Power inlet/fuse holder: Insert supplied power cord.
6. Recording DI out: Take your DI line for a recording console
or desk from.
7. Effects return left and right: Return your Stereo signal from
your external processor or effects chain.
8. Ground Lift Switch: Turns ground lift function off/on.
9. DI level control: Adjust the DI output level.
10. Aux input: Input your left and right auxiliary inputs.
IMPORTANT: Your amplifier has been engineered and built to function only for the voltage shown on the rear of the unit. To
use this unit under different voltage conditions you will either require a suitable power conditioner or modifications to the
amplifier which should only be undertaken by qualified Eden approved engineers. In addition your unit was supplied with the
correct fuse fitted and a replacement fuse. To obtain additional replacements you should contact your nearest Eden dealer or
a qualified Eden technician.
E D E N | W O R L D T O U R S E R I E S | W T 8 0 0 - 7
26. Limit indicators: These illuminate when either the left or
right (or both) amplifiers have reached their output limits.
27. DC indicator: This illuminates to indicate low voltage supply
is working.
28. Mains switch: Illuminates when unit is switched on.
11. Effects send
or effects chain.
12. Tuner output
13. Pre FX: Send and Return input your signal from your
external processor or effects chain (before the EQ stage).
14. Speakon output (Right Amplifier): Connect your
amplifier to a single speaker cabinet.
15. Speaker output 1 (Right Amplifier): Connect your amplifier
to a speaker.
16. Speaker output 2 (Right Amplifier): Connect your amplifier
to a second speaker.
H I F I D E L I T Y F O R L O W F R E Q U E N C Y
:
Take your signal for an external processor
:
Connect your external tuner.
| 1 5