Descargar Imprimir esta página

Troy-Bilt 020213 Instrucciones De Uso página 9

Publicidad

Idiomas disponibles

Idiomas disponibles

Section 3: Assembly
Connect
Hose
and Water
Supply
to
Pump_
iMPORTANT:
To avoid pump damage, you must assemble
the nozzle extension to the spray gun and attach all hoses
before you start the engine.
NOTE:
Remove and discard the shipping caps from the
pumps high pressure outlet and water inlet before
attaching hoses.
I.
Uncoil high pressure hose and attach one end of hose
to base of spray gun (Figure 5).Tighten by hand.
_
hose here
2.
Attach other end of high pressure hose to high
pressure outlet on pump (Figure 6).Tighten by hand.
4.
Run water through your garden hose for 30 seconds
to clean out any debris.
iMPORTANT:
DO NOT siphon standing water for the
water supply. Use ONLY cold water
(less than 100°F).
5.
Connect the garden hose (not to exceed 50 feet in
length) to the water inlet.Tighten
by hand (Figure 7).
CAUTION
Damage to equipment resulting from failure to follow this
instruction will void warranty.
Turn ON the water and squeeze the trigger on the
gun to purge the pump system of air and impurities.
WARNING
Always wear safety goggles when using this equipment
or in
vicinity
of where equipment
is in use.
Before starting the pressure washet, be sure you are wearing
adequate safety goggles,
Before connecting
garden
hose to water
inlet, inspect
inlet screen
(Figure 7). Clean screen
if it contains
debris
or have it replaced
if damaged.
DO NOT RUN
PRESSUREWASHER
IF INLET SCREEN IS DAHAGED
OR HISSING.
\\
screen, DO NOT
use if damaged;
clean if dirty.
Inspect inlet
Checklist
Before
Startin EgEn_ine
Review the unit's assembly
to ensure
you have performed
all of the following.
I.
Hake sure handle
is in place and secure.
2.
Check that oil has been added
to proper
level in the
engine
crankcase.
3.
Add proper
fuel to fuel tank.
4.
Check for properly
tightened
hose connections.
5.
Check to make sure there
are no kinks, cuts, or
damage to high pressure
hose.
6.
Provide a proper
water
supply at an adequate
flow.
7.
Be sure to read "Safety Rules" and "HowTo
UseYour
Pressure
Washer"
before
using pressure
washer.
O

Publicidad

loading