Warranty Information - General Tools & Instruments TOOLSMART TS06 Manual Del Usuario

with 11% moisture content. But in bone-dry Nevada, Utah,
and Arizona, where 30% humidity is common, the same
piece of wood would have to have less than 6% moisture to
be considered "ready for finishing".
• To locate the source of a leak behind wood, plaster, drywall
or a ceiling, make measurements at different locations. The
leak is where the meter displays the highest reading.
• Never use force to drive the test pins into a hard surface.
• Do not operate the TS06 in the presence of flammable or
explosive gases.
• Be careful not to stab yourself with the extremely sharp test
pins.
• Replace the protective pin cap and black rubber protection
sleeves after making measurements 1) for safety reasons
and 2) to avoid bending or dulling the pins.
• After subjecting the meter to a large change in ambient
temperature, wait at least 30 minutes before making
measurements to guarantee the accuracy of readings.
• Remove the battery when storing the unit or when you do
not expect to use it for an extended period of time (months
rather than weeks).

WARRANTY INFORMATION

In the U.S, General warrants its instruments and accessories,
and digital tools against defects in material or workmanship for
one year from the date of purchase unless otherwise stated on
the packaging, manual, and/or marketing materials. General
also warrants its non-digital tools products against defects in
material or workmanship on a limited lifetime term. The
company will replace or repair the defective unit, at its option,
subject to verification of the defect.
1