Hilti SC 60W-A36 Manual Del Usuario página 24

9.1 The circular saw is in working order.
Trouble or fault
The power tool vi-
brates more than
usual.
Running speed sud-
denly drops consid-
erably.
9.2 The circular saw is not in working order.
Malfunction
No response from
the LEDs on the bat-
tery.
1 LED on the battery
flashes.
4 LEDs flash.
16 English
Printed: 04.06.2018 | Doc-Nr: PUB / 5389747 / 000 / 01
Possible cause
The saw blade is fitted
incorrectly.
The battery is
discharged.
Saw advance pressure
is too high.
Saw blade is too badly
worn.
Possible cause
The battery is not cor-
rectly inserted.
The battery is
discharged.
The battery is too hot or
too cold.
The battery is
discharged.
The battery is too hot or
too cold.
The circular saw was
overloaded briefly.
The overheating preven-
tion cut-out has been
activated.
Action to be taken
▶ Remove the saw blade
and refit it correctly.
▶ Change the battery
and charge the empty
battery.
▶ Reduce advance
pressure and switch
the power tool back
on.
▶ Insert a new saw
blade.
Action to be taken
▶ Push the battery in
until it engages with a
click.
▶ Change the battery
and charge the empty
battery.
▶ Bring the battery to
the recommended
working temperature.
▶ Change the battery
and charge the empty
battery.
▶ Bring the battery to
the recommended
working temperature.
▶ Release the control
switch and then press
it again.
▶ Allow the circular saw
to cool down and
clean the air vents.
2172267
*2172267*